DJI Osmo Action 5 Pro Mount

1

Just bought a DJI Osmo Action 5 Pro and thinking about buying another one and start using ActionStitch.
Is there a mount diagram for Action 5?
If I order it from craftcloud3d.com which material should I use? I’m planning on connecting the mount to a 1/4" tripod adapter

Thanks!

2

I’m wondering the same but for the DJI Osmo Action 4. What 3d print should I use to mount them both together?

3

There is a mount for DJI Osmo Action 3: actionstitch-player/mounts/osmo_action_3.stl at main · gilbertchen/actionstitch-player · GitHub

According to DJI Osmo Action 4 vs Osmo Action 3 Comparison: What is new and is it worth upgrading?, the bottoms of 3, 4, and 5 are the same size.

4

Just a quick update.
I ordered a mount from craftcloud3d.com based on the Osmo Action 3 file and it doesn’t fit.
I tried with or without the protective frame but no luck.
Action 5 Case

For now I will try using a dual mount bracket such as this one

I was wondering how should I position 2 DJI Action 5 (90 degrees or less)

5

I apologize for the wrong information. Apparently I was browsing that page on my phone and didn’t notice there were slight differences in the dimensions of Osmo Action 3, 4, and 5.

However, I think you can use a heat gun or hair dryer to “soften” the 3d printed mount to make it stretchable and then you might be able to fit the camera into the mount. Even hot water may work too.